Avid Technology System 5 Especificaciones descargar pdf (Pagina 96)

S3L System Guide92

Inserting Built-In Graphic EQs on Outputs

Built-in 31-band Graphic EQs can be inserted on Mains, Groups,

Auxes, and Matrixes. 16 Graphic EQs are available.

To insert a Graphic EQ on an Output bus:

1 Go to the Outputs page and select the bus where you want to

insert the Graphic EQ.

2 Click the 31-Band Graphic Equalizer tab.

3 Click the Graphic EQ selector and choose an available mono

or stereo Graphic EQ.

The entire Graphic EQ is displayed on-screen.

Adjusting On-Screen Output Controls

The software screen Output section lets you adjust output param-

eters on-screen.

To adjust output parameters on-screen:

1 Select an output channel.

2 Adjust the on-screen controls as needed:

• For controls such as the fader and delay, click the

fader/knob and drag to adjust the parameter.

• For Mute and Polarity Invert, click the buttons to toggle

their state.

To reset an on-screen output parameter to its default value, do

one of the following:

 Alt-click the control.

– or –

 Right-click the control and choose Reset.

To reset an entire output channel to its default settings:

1 Put the system into Config mode.

2 Right-click the on-screen fader for the output you want to reset

and choose

Reset <name of output>.

Selecting a Graphic EQ

For information on configuring and using Graphic EQs, see

“Graphic EQ for Outputs” on page 156.

On-screen Output controls

Resetting a channel also deassigns any plug-in, hardware

input and GEQ assigned to the channel.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 312 313

Sin comentarios

Avid Technology System 5 Especificaciones Pagina 96