Avid Technology AirSpeed 5000 Especificaciones descargar pdf (Pagina 155)

Identifying and Replacing Failed Video I/O Boards

142

3. You can now remove the failed Video I/O board from the chassis.

To remove failed VIO boards:

1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on

page 76 and “Safety and Regulatory Information” in the AirSpeed 5000 Setup Guide.

2. Power down the server and unplug all peripheral devices and the AC power cables.

3. Remove the server cover. For instructions, see “Removing and Replacing the Server Main

Cover” on page 134.

4. Disconnect any cables attached to any add-in cards.

5. Loosen the thumbscrews on the back cover, and slide the cover back to remove it from the

chassis.

The following diagram shows the location of the two (2) thumbscrews on the rear of the

server.

6. Loosen the thumbscrew on the card guide, and slide it over to remove it from the chassis.

The following diagram shows the location of the Card guide thumbscrew.

Two (2) Thumbscrews

Card Guide thumbscrew

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 206 207

Sin comentarios

Avid Technology AirSpeed 5000 Especificaciones Pagina 155