Avid Technology AirSpeed 5000 Guia de preparacion descargar pdf (Pagina 69)

Connecting the Power Cords

The last step you must perform when cabling up your AirSpeed 5000 is to connect the power

cords. Two U.S. IEC power cords are shipped with the unit. If your local power distribution is

not compatible with the supplied cords, you must provide your own IEC power cables that are

compatible with your country’s power system. The power connector accepts 100 to 240 Vac,

50/60 Hz.

To connect power:

1. Attach the power cords to both power receptacles on the rear of the AirSpeed 5000.

2. Connect the other end of both power cords to a properly grounded stable power source.

The system will power on after you connect the first power supply. The Monitor application

will also automatically launch.

Once powered on, you must set up your system. For more information, see “Turning On the

Avid AirSpeed 5000 Server” on page 56.

For maximum power protection, Avid recommends a surge protected un-interruptible

power supply (UPS).

Power Supply 2

LAN1

LAN2

LAN3

LAN4

Power Supply 1

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 137 138

Sin comentarios

Avid Technology AirSpeed 5000 Guia de preparacion Pagina 69